Regenerative Braking - Drag the slider to choose how much regenerative braking is available.The default setting of 0 represents a balance which provides some stability being automatically controlled and leaving some control up to the driver. Choosing +10 engages all stability assist systems for controllable driving in which stability systems remain engaged, whereas -10 disables all stability systems and the stability of the drive rests solely on the driver. You can choose any level from -10 to +10. Stability Assist - Drag the slider to choose the level at which the stability control systems assist in controlling the vehicle.You can select any value, in 5% increments, between 100/0 (for 100% front biased used for under-steering) and 0/100 (for 100% rear biased used for over-steering). Difficult to get the vehicle through a turn? Try a rear-biased setup to increase rotation. If Model 3 is too loose, you can choose a front-biased under-steering setup. Handling Balance - Drag the slider to customize the balance of Model 3 in a turn.Or create a new settings profile by touching Add New Settings, entering a name for the settings profile, then adjusting these settings to suit your preferences or driving scenario, or customize for a specific track: Choose an existing Track Mode setting from the list of pre-defined profiles provided by Tesla. You can also access the Track Mode settings by touching Controls > Pedals & Steering, then touching Customize next to the Track Mode setting. To customize Track Mode, touch Track Mode Settings on the Track Mode popup window that appears on the map when you enable Track Mode. When Track Mode is off, all settings return to their previous state and all features return to their normal operating state. Powering off Model 3 also turns off Track Mode (although it may still appear on the touchscreen if Post-Drive cooling is in progress). Use the touchscreen setting to turn Track Mode off at any time. Entertainment features are unavailable.Stopping Mode is set to the Roll setting in which Model 3 is free-rolling at very low speeds whenever Drive or Reverse is engaged and both the accelerator and brake pedal are released.You can also view a real-time accelerometer (G-meter) by swiping the Cards area of the touchscreen. If you started the Lap Timer, each time you pass the start/finish location, the timer resets for the next lap. Once started, the Lap Timer starts counting when you drive Model 3 past the lap's start/finish location where you dropped the pin. You will then need to press START on the Lap Timer to begin your driving session. If you want to use the Lap Timer, follow the onscreen instructions to drop a pin on the map to define the lap's start/finish location.If desired, customize the Track Mode settings by touching Track Mode Settings on the Track Mode pop up window (see Customizing Track Mode).
The car status area of the touchscreen displays a color-coded image of your Model 3 that provides you with important at-a-glance status information about the Battery, the motors, the tires and the brakes. When enabled, TRACK displays on the touchscreen above the driving speed, and a Track Mode pop up window appears on the map. Touch Controls > Pedals & Steering > Track Mode.To enable Track Mode for your current drive, shift into Park and follow these steps: Track Mode is always disabled when you start Model 3.
0 kommentar(er)
